Specifications; Fcc Warning - Kenwood 1050CD Instruction Manual

Specifications
a
1050CD 104CD/103CD
[Format] [Format]
System . Compact disk digital audio system System . . Compact disk digital audio system
Laser... Semiconductor laser Laser. Semiconductor laser
[D/A convertors]
D/A conversion .
Oversampiing
. 8 fs (352.8 kHz)
[Audio]
Frequency response
Signal to noise ratio
Dynamic range a
Total harmonic distortion + noise
4 Hz ~ 20 kHz, 20.5 dB
... More than 100 dB
More than 95 dB
Less than 0.004% {at 1kHz)
Wow & flutter Unmeasurable limit
Output level/impedance
Variable .. (Max.) 2.0 V/0.8 kQ
Headphone output (max.) ... 20 mW (32 2)
(General]
Power consumption 13 W
Dimensions.... Ws: 440 mm (17-5/16")
HH: 125 mm {4-15/16")
BD 397 mm (15-5/8")
Weight (Net)
. 5.0 kg (11.0 Ib)
Note:
[D/A convertors]
D/A conversion
Oversampling....
1 Bit
. 8 fs (352.8 kHz}
[Audio]
Frequency response
Signai to noise ratio
Dynamic range ....
Total harmonic distortion + noise
4Hz ~ 20 kHz, 20.5 dB
More than 95 dB
More than 95 dB
. Less than 0.008% (at 1kHz}
Unmeasurable limit
Wow & flutter
Output level/impedance
Fixed (103CD)
Variable (104CD)
Headphone output (max.}
2.0 V/0.8 kQ
. (max.) 2.0 V/0.8 kQ
{104CD only} 20 mW (32 0)
[General]
Power COmSUMPTION «0.00... s c e c e e c e e s e s e n e s e s e s s e c a n e s t s s c t s e a s s e s e n e a s s 13 W
Dimensions . We: 440 mm (17-5/16")
H =: 125 mm (4-15/16")
Oo 397 mm (15-5/8")
Weight (Net) .. .. 5.0 kg (11.0 Ib)
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this equiprnent may cause harmful interference unless
the modifications are expressly approved in the instruction manual, The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interfer-
ence to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determinded
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—~ Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver 1s connected.
~- Consuit the dealer or an experienced radio/TV technician for help.
L
1OSOCD/104CD/103CD (En) 23