Yamaha 01X Software Installation Manual page 8

Installation of mLAN Bus Driver(mLAN Stream Driver)
18
The "New Hardware Wizard" automatically appears.
Check the radio button next to "Install the software automatically [Rec-
ommended]," and click [Next] to start installation.
19
When installation is finished, a "Complete" message appears. Click
[Finish].
Installation of Install mLAN for 01X(mLAN Software)
When the pre-install routine is finished, a "Welcome" display appears.
Click [Next].
20
Determine the desired destination drive and folder name for installa-
tion in the "Destination Directory" window. The destination directory is
automatically set; however, if you wish to change it, click the
[Browse...] button and select the desired folder (drive:\folder name).
• To cancel the installation, click [Cancel].
21
Confirm the drive and folder name and click [Next] to start installation.
• To cancel the installation, click [Cancel].
22
A message prompting you to turn on the 01X appears. Turn on the
power of the 01X.
8
TOOLS for 01X/Plug-in Effect Installation Guide
23
When installation is finished, a "Complete" message appears. Click
[Finish].
• For information on the "Waiting" display, see below.
Registering the ports for the mLAN Driver
24
The "New Hardware Wizard" automatically appears.
Check the radio button next to "Install the software automatically [Rec-
ommended]," and click [Next] to start installation.
• It may take some time for the initial "New Hardware Wizard" window to appear.
"Waiting" display
If the connection of the 01X (or other hardware) is found while the
installation is in progress, the "Found New Hardware Wizard"
screen automatically appears in Windows XP. The "Waiting" dis-
play indicates this information.
The number of times that the Waiting display appears differs depending on the
audio driver selected in the Setup Type display.
ex. )
• Do not close the Waiting display, unless you've made a mistake (for exam-
ple, if you've interrupted the installation by mistakenly clicking Cancel), or
when the Wizard does not finish properly because of an error. The Waiting
display automatically closes when the Wizard properly finishes.
• Do not close the Waiting display by performing a [CTRL] + [ALT] +
[DELETE]. This results in improper termination of installation of Tools for
01X.
Proceed to the next step.