Table of Contents
Advertisement
ELECTROSTATICALLY SENSITIVE DEVICES
Many solid-state devices (especially Integrated
Circuits) are Electrostatically Sensitive, and, therefore,
require special handling techniques as described
under "Servicing Electrostatically Sensitive Devices,"
on page two in this service literature.
LCD PANEL REMOVAL
1. Remove 8 screws to take the mounting panel off.
(A:3x6, 6pcs; D:4x8, 2pcs.)
2. Remove 6 screws to take the inverter unit off.
(E:2.5x6, 2pcs.)
3. Lift up the LCD panel from front cabinet.
SPEAKER REMOVAL
Take off each speaker from back cabinet
[ ATTENTION ]
Confirm Mounting Wall Wire is installed when you install
the back cabinet.
KEY SW BOARD REMOVAL
Remove 1 screw (C:3x14) to take the
KEY SW board off.
RC LED BOARD REMOVAL
Remove 1 screw (C: 3x14) to take the
RC LED board off.
Inverter Unit
E
E
E
D
C
KEY SW Board
Back cabinet
– 7 –
Mounting Panel
E
D
E
E
A
A
Mounting Wall Wire
Front cabinet
A
LCD Panel
C
RC LED Board
Advertisement
Table of Contents
