Power Lamp And Alarm Lamp Flash Alternately - Canon PIXMA iP6220D Series Quick Start Manual

Troubleshooting
....
"Error No.:1700"
"Error No.: 2001"
"Error No.: 2500"
.
.
Waste ink absorber
almost full
A specified period
of time has elapsed
without receiving a
response from the
digital camera/The
digital camera or
digital video
camcorder
connected is not
compatible with
this printer
Automatic print
head alignment
failed
The printer has a built-in waste ink absorber to hold the ink used during print
head cleaning, for example. This error message indicates that this ink absorber
is nearly full.
Press the OK button to clear the error so you can continue printing. Before the
waste ink absorber becomes completely full, contact the Customer Care Center.
When you experience this error, you will need to call for servicing to replace the
waste ink absorber and to check the printer for proper operation.
Disconnect the camera cable, and reconnect it.
EEl
Note
Depending on the model or brand of your device, you may have to
select a print mode compliant with PictBridge before connecting
the device.
You may also have to turn on the device or select Play mode
manually after connecting the device to the printer.
Perform necessary operations according to the instruction
manual supplied with your device.
If the error is still unresolved, there is a possibility that you are using a digital
camera or digital video camcorder that is not supported by this printer. Use a
digital camera or digital video camcorder compatible with this printer.
Refer to "An Error Message is Displayed on the LCD" in the
Direct Printing Guide.
POWER Lamp and Alarm Lamp Flash Alternately
Problem
I
Possible Cause
I
Try This
POWER Lamp and
Alarm Lamp Flash
Alternately
28
An error that
requires contacting
the Customer Care
Center may have
occurred
Disconnect the printer cable from the printer, and then turn the printer off and
unplug the printer from the power supply. Plug the printer back in and turn the
printer back on after leaving it for a while.
If the problem remains, contact the Customer Care Center.