Yamaha K-1020 Owner's Manual page 13

А NATURAL SOUND STEREO CASSETTE DECK каого
YAMA:
Sendcust Э Haad
Glesad Loop Dun! Capstan mechsn:sm
MASTER FACER
dbx B ООба] рас Orare Sas Serve
T LEFT її! ШЇ ш Д
T E Km "Жемде
n i i ЇЙЇ
(ЕЕЕ [BAS m-1-* Fever (Cg
E HOW TO PLAYBACK
* Before playback
Refer to connection diagram. Check that leads and power cords
between units are correctly wired.
(D Set AUTO MODE selector to OFF.
(2) Set POWER switch to ON. |
(8) Press EJECT button, open the cassette holder and load a pre-
recorded cassette tape.
(4) For a tape recarded with a noise reduction system, press either
the Dolby B, Dolby В or арх NR button according to the system
used.
е Beginning playback
(9 Press the PLAY button. The deck enters the playback mode.
(6) Adjust the OUTPUT LEVEL control.
Set the volume and tone controls on the amplifier to adjust
sound quality as desired.
(7) To stop playback, press the STOP button.
ә Repeated playback of a selection
Using the AUTO MODE and MEMORY, the deck can play one or
more selections repeatedly up to 8 times.
Auto stop at the
memory position
MEMORY
Playback
Auto play Auto stop
Rewind
. Repeat playback (8 times)
1. Load a pre-recorded tape, and begin playback.
2. Set AUTO MODE selector to REPEAT 0-M position.
3. Press RESET button at the beginning of the selection you want
to play again, and set the counter to 0.00".
4. Press the MEMORY button at the end of the selection you want
to play again.
The MEMORY indicator lights up and the tape immediately
begins rewinding.
5. The tape is rewound until the counter has returned to "0.00"
(beginning of selection). The deck then enters the playback
mode.
6. The tape plays back until it reaches the memorized counter
number (end of selection). In this way, the same selection can
be played again.
7. To erase the memory, press the MEMORY button once again.
The Memory indicator goes out.
e When the memory position is at a — (minus) reading, commence
playback from the memory position. The tape will automatically
stop when "0,00" is reached, whereupon the tape will be
rewound, and playback will be repeated between the above
two points.
Auto play Auto stop
Rewind
е Repeated playback of one side of a tape
1. Set the AUTO MODE switch to the REPEAT FULL position.
2. Load a tape, and the deck for playback. One side of a tape is
played back up to 8 times. m =
12