Pioneer F-99X Operating Instructions Manual page 6

PRESETTING
Tune in desired station.
e
See the AUTO SEARCH section for information on recep-
tion using Auto Search.
e See the MANUAL
SEARCH
section for information on
reception using Manual Search.
When presetting using Mode 1 STATION CALL switches
STATION CALL
Not lit
STATION
CALL
When presetting using Mode 2 STATION CALL switches
. STATION CALL
Lit
5 When station is tuned in, press the
MEMORY switch.
e The Memory indicator lights.
6 Press the STATION CALL switch into
which you wish to preset the station.
e Perform presetting during the time that the Memory in-
dicator is lit.
e If the Memory indicator goes out, presetting is no longer
possible. Press the Memory switch again to perform
presetting.
7 Repeat steps 2 to 6 to preset stations into
switches 1 through 16.
Up to 16 AM and FM stations may be memorized.
If you accidently preset a station into a STATION CALL switch
which contains information, it will be erased and the new sta-
tion will be entered instead.
6
NOTE:
STATION CALL switches may be used to (1) Preset FM and AM
stations in any order, or (2) preset FM stations in switches 1 through
8 and AM stations into 9 through 16. In the second case, the STA-
TION MODE switch acts as the FUNCTION switch as well.
RECEPTION USING PRESET TUNING
wane c
1 Turn on the POWER switch of the unit and
a stereo amplifier.
2 Press the STATION CALL switch into
which the desired station has been preset.
(When necessary, do not neglect to per-
form Station Mode selection as well.)
Tuning can be performed simply and accurately by following
the above procedure.
NOTES:
e Preset stations will be retained in the MEMORY when
the POWER is switched OFF as long as the POWER
cord is not disconnected.
e /t is recommended that you disconnect the POWER
cord when the unit is not being used for long periods of
time. The electrical circuit controlling the MEMORY
function is powered by a BACK-UP CONDENSER so
that the unit will retain preset stations for a period of up
to 3 days.
e /f a preset station has been erased, reset It.
Last station memory
e When the POWER switch is pressed to turn power
on, the last station received before the power was
previously turned off will be received again.
e When power is ON, if the FUNCTION selector
switch is pressed, the last station received before
the FUNCTION switch was previously pressed will
be received again.