Advertisement
ADJUSTMENT
2.4 AUTO LEVEL ADJUSTMENT
* Connection Diagram (Shown in Fig. 4)
¢ To Adjust
1. Select the band switch to AUTO position.
2. Set SSG at 98MHz and tune using the tuning knob.
3. Set SSG to an output level of 20 dB (uV), and adjust
VR2 to a separation of 5 dB (between the right and left
channels).
2.5 AM IF ADJUSTMENT
(KE-5000)
¢ Connection Diagram
TUNER/ PRE AMP
UNIT
468 kHz
Generator
Scope
Terminating
Resistor
° To Adjust
1. Set Generator Scope as follows:
Frequency centering on sweep ............... 468kHz
inputlevel
00... 0...
cece
eee
ee eee 0.3 Vp-p/cm
Output level...
6...
ee ccc eee
3mVv10 mV
2. Turn the core of T5 and adjust so that U-curve will be at
maximum amplitude and best symmetry.
Fig. 5
Advertisement
