Table of Contents
Advertisement
Cleaning and care
Plinth filter
Only clean the plinth filter when the
indicator lights up.
To turn the indicator light off: open
and close the door while the dryer is
switched on.
Removing the plinth filter
Press the round, indented area on the
heat exchanger access panel to open
it.
The panel will spring open.
Pull the plinth filter out by the handle.
40
Removing the plinth filter will cause the
right hand guide pin in the dryer to
come out. This pin ensures that the
heat exchanger access panel can only
be closed if the plinth filter is inserted
the right way round.
Cleaning the plinth filter
Pull the handle out of the plinth filter.
Clean the filter thoroughly under run-
ning water.
Squeeze the water out of the plinth
filter thoroughly.
The plinth filter must not be replaced
dripping wet. This can cause a fault.
Use a damp cloth to remove any fluff
from the handle.
Advertisement
Table of Contents
