Table of Contents
Advertisement
Tip: You can also control the radio from the menu.
Press
, select
command.
To listen to the radio through the headset or
loudspeaker, make sure that the headset is connected
to the device, press
use
>
Headset
or Loudspeaker. The lead of the headset
functions as the radio antenna, so let it hang freely.
To adjust the volume, tap and drag
press
and
To tune radio channels manually, tap
To search for channels automatically, tap
. Searching stops when a channel is found.
To view available channels based on location, press
, and select
location and radio station. Visual Radio tunes to that
station automatically. To save the channel to a list of
preset channels, tap Save. See "Preset channels" on
page 88 for details. To view station details, such as
the visual service ID, tap Details.
To switch to stereo or mono output mode, press
and select
Tools
Viewing content
To view available visual content, select the preset
channel, and tap
tap
. Note that you must have the correct visual
88
Radio
and an appropriate menu
, and select
Tools
>
Speaker in
.
or
Tools
>
Channel
directory.... Select a
> Sound>
Stereo
or Mono.
. To stop viewing visual content,
service ID defined and have Visual Radio service
enabled. See "Preset channels" below for details.
Preset channels
You can save up to 20 radio channels to Visual Radio.
To save a channel, tap
station. Press
a channel slot and write a name for the preset channel.
, or
Change the frequency, if necessary. If the station
provides visual content, add the Visual Radio service
.
ID, and select the
or
allow for visual content.
Tip: To find the visual service ID of a channel, press
, and select
radio station, and tap Details.
To listen to a preset channel, tap on a channel in the
list view.
To edit a preset channel, press
Channel
> Edit....
To reorder preset channels, select a channel, press
, and select
slot in the list. Press the centre of the scroll key to
confirm the move.
To remove a preset channel, press
Channel
> Delete.
and
to tune in to a
, and select
Channel
> Save.... Select
Enable visual service:
check box to
Tools
>
Channel
directory.... Select the
, and select
Channel
> Reorder.... Select a channel
, and select
Advertisement
Table of Contents
