Remove The Speakers; Remove The I/O Bracket - Lenovo ThinkBook 13s Gen 4 Hardware Maintenance Manual

Hide thumbs Also See for ThinkBook 13s Gen 4:
Table of Contents

Advertisement

Go to
https://support.lenovo.com/partslookup
replacement parts:
Solid-state drive (SSD)
Solid-state drive (SSD) thermalpad

Remove the speakers

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Disconnect the speaker cable from the I/O board. Release the speaker cable from the cable guide
and then remove the speakers.
Figure 8. Remove the speakers
Go to
https://support.lenovo.com/partslookup
part:
Speakers

Remove the I/O bracket

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Peel off the pieces of tape.
to look up the Lenovo part numbers of the following
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
31

Advertisement

Table of Contents
loading

Table of Contents