Dell OptiPlex 210L User Manual page 127

Expansion Bus
Bus type
Bus speed
Cards
PCI:
connectors
card size
connector size
connector data width
(maximum)
PCI Express:
connectors
power
connector size
connector data width (maximum)
Drives
Externally accessible
Internally accessible
Connectors
External connectors:
Serial
Parallel
Video
Network adapter
USB
Audio
System board connectors:
Primary IDE drive
Serial ATA
Floppy drive
Fan
PCI 2.3
CD drive audio interface
Front panel
Key Combinations
<Ctrl><Alt><Del>
<F2> or <Ctrl><Alt><Enter>
<Ctrl><Alt><b>
<F12> or <Ctrl><Alt><F8>
PCI 2.3
SATA 1.0a
USB 2.0
PCI: 33 MHz
SATA: 1.5 Gbps and 3.0 Gbps
USB: 480 Mbps
low-profile cards supported
two
low profile
120 pins
32 bits
one x1
10 W maximum
36 pins
one PCI Express lane
one 3.5-inch drive
one bay for CD/DVD or optional second hard drive
one bay for a 1-inch-high hard drive
9-pin connector; 16550C-compatible
25-hole connector (bidirectional)
15-hole VGA connector
RJ45 connector
two front-panel and four back-panel USB 2.0–
compliant connectors
three back connectors for line-in, line-out, and
microphone; one front-panel connector for
headphones
40-pin connector
two 7-pin connectors (only one used)
NOTE: The SATA2 connector is not supported on this
system.
34-pin connector
5-pin connector
120-pin connector
4-pin connector
40-pin connector
in Microsoft® Windows® XP, brings up the Windows
Security window; in DOS mode, restarts (reboots) the
computer
starts embedded system setup (during system start-
up only)
automatically starts the computer from the network
environment specified by the remote boot
environment (PXE) rather than from one of the
devices in the system setup Boot Sequence option
(during system start-up only)
displays a boot device menu that allows the user to
enter a device for a single boot (during system start-
up only) as well as options to run hard-drive and