Connecting With The Discharge Tube; Operation; Emptying The Grass Bags; Discharge Tube - Toro 79393 Operator's Manual

7
Connecting with the Discharge
Tube
Parts needed for this procedure:
1

Discharge tube

Procedure
1. Slide the curved end of the discharge tube into the
opening in the bagger top
2
1
3
4
Figure 28
1. Discharge tube
2. Opening in bagger top
3. Discharge tube, flared end
2. Slide the flared end of the discharge tube over the end
of the chute. Move the rubber retaining strap on the
chute over the peg on the discharge tube to secure it
(Figure 28).
3. After the bagger installation, install the wire onto the
spark plug(s).
(Figure 28).
G010641
5
4. Peg
5. Rubber strap

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
WARNING
To avoid personal injury, follow these procedures:
• Become familiar with all operating and safety
instructions in the Operator's Manual for the
mower before using this attachment.
• Never remove the discharge tube, bags, bagger
top, or the chute while the engine is running.
• Always shut the engine off and wait for all
moving parts to stop before clearing an
obstruction from the bagging system.
• Never do maintenance or repairs while the
engine is running.

Emptying the Grass Bags

Be careful when lifting or handling a grass bag that is full. To
empty the grass bags:
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, set the
parking brake and wait for all moving parts to stop
before leaving the operating position.
3. Open (raise) the bagger top
4. Compress debris into the bags. With both hands, lift up
on the bag and unhook it from the retaining bracket.
Empty the bag. Repeat the procedure for the other bag.
5. Install the bags by sliding the bag frame hooks onto the
retaining brackets
15
(Figure 29).
G005758
Figure 29
(Figure 30).