Advertisement
5.2.
BEARING INSTALLATION (fig.4 & fig.5)
WARNING! DO NOT fit a bearing with a damaged retaining ring.
‰
Note: The bearing must only be subjected to force on the outer bearing race behind the retaining ring during installation. Using a
workshop press on the hub flange to insert the bearing will cause premature failure or destroy the bearing during installation.
5.2.1.
The silver hub clamp (3,4) sits in the space between the rear of the hub flange and the retaining ring (fig.5). Secure hub clamp (3,4)
with the hub clamp screws (12).
5.2.2.
Fit the hub guide pins (10) into the thrust plate (11) so that the hub guide pins (10) align with the holes in the hub flange. Place the hub
guide pins (10) though the holes in the hub flange so that they sit against the hub clamp (3,4).
5.2.3.
Lubricate the force screw (2).
5.2.4.
Offer the bearing and assembled kit to the hub carrier. Ensure that the bearing is sitting square to the hub carrier before commencing
installation.
5.2.5.
Fit the force screw (2) through the thrust plate (11) and through the bearing and hub carrier.
5.2.6.
Place the bearing plate (7,8) over the force screw (2) so that it sits on the outer edge at the rear of the hub carrier.
5.2.7.
Screw the sleeved nut (9) over the force screw (2) so that it sits against the bearing plate (7,8).
5.2.8.
Use a socket on the force screw (2) and a spanner on the sleeved nut (9). Draw the bearing into the hub carrier.
5.2.9.
When the bearing is correctly installed, the retaining ring will clip into the retaining groove.
fig.4
The force screw maximum torque is 150Nm. Exceeding this will shorten the life of the force screw. The force screw is considered
to be a consumable item and is NOT covered under warranty.
ALWAYS KEEP THE FORCE SCREW
WELL LUBRICATED. A COPPER BASED
LUBRICANT IS RECOMMENDED.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.5
DO NOT USE AIR TOOLS
sales@sealey.co.uk
Original Language Version
X
www.sealey.co.uk
VS7029.V3 Issue:1 07/08/23
REGISTER YOUR
PURCHASE HERE
Advertisement
