Table of Contents
Advertisement
Important Safety Precautions
tion and service manuals.
Parts identified by the
/\ symbol and shaded
critical for safety.
Replace only with specified part numbers.
parts are
Fuse replacement caution notice.
Caution
for continued
protection against fire hazard.
Replace only with same type and rated fuse(s) as specified.
i
ita
SL
S
Cut close to connector
Fig. 3
2) Double insulated wires
3) High voltage leads
(2) Strip about 15 mm
of the insulation from the ends of the
wires. If the wires are stranded, twist the strands to avoid
frayed conductors.
(3) Align the lengths of the wires to be connected. Insert the
wires fully into the connector.
Fig. 1
Metal sleeve
. Observe
that wires do not contact heat producing
parts (heat-
sinks, oxide metal film resistors, fusible resistors, etc.)
Connector
_ Check that replaced wires do not contact sharp edged or pointed
(4) As shown in Fig. 6, use the crimping tool to crimp the
force in any direction will not loosen it.
meta! sleeve at the center position. Be sure to crimp fully
to the complete closure of the tool.
Power cord
Crimping tool
Fig. 6
_ Products using cathode ray tubes (CRTs)
Not easily pulled free
Crimped at approx. center
of metal sleeve
Conductors extended
Wire insulation recessed
more than 4 mm
Fig. 7
Advertisement
Table of Contents
