Table of Contents
Advertisement
Front Panel Controls and Functions
(continued)
0 Sound effect level control (SOUND JOG)
This control is used for adjusting the level of the ambience
enhancement effect and the equalization level.
0 Ambience enhancement button (SPACE)
This button is used to activate ambience enhancement mode.
0 Spectrum mode-eelect/demonetratlon button
(-SPECTRUM MODE—DEMO)
This button is used to select one of the six spectrum curves. If
you press and hold this button, six types of sound effects
(spectrum curve in combination with ambience enhani^m^t)
will be sequentially changed (Demonstration mode).
0 Super base Indicator
Illuminates when the super bass mode is activated.
0 Super bass button (SUPER BASS)
Virtien this button is pressed, the dynamic tow frequency
ranges are boosted.
0 Volume preset button (VOL. PRESET)
This button is used to make a volume presetting.
0 Volume level control (VOLUME)
This control is used to adjust the volume level (-82 d6~
0 dB). Note that -82 dB is the lowest volume setting and 0 dB
is the highest level setting.
0 Equalization function button (ON/FLAT)
This button is used to switch the equalization correction
function. If no equalization correction is desired, press this
button agctin to cancel the function.
0 Headphones Jack (PHONES)
0 Microphone Jack (MIC)
0 Equalization mode-select/recall button
(-MODE—RECALL)
This button is used to retrieve a pre-programmed equalization
curve from the memory. If you press and hold this button, a
curve you programmed can be retrieved.
® Input selectors and Indicators
These selectors are used to select the sound source to be
heard. When the sound source is selected, the indicator
above the selector will illumirtate.
@
Standby Indicator (STANDBY)
This indicator illuminates when tiie power "STANDBY c!)/ON''
switch of the unit or that of the remote control is switched
"OFF". Its purpose is to alert the user of the constant supply
voltage to the internal circuitry even with the power switch
OFF.
For this unit, even if this switch is switched to the "STANDBY*
position, there is still a slight power consumption of about
17 watts: this is in order to retain of the "most recent" memory
and the preset-memory functions.
-
16
-
Advertisement
Table of Contents
