Normal Playing; Programmed Play; Additional Information - Philips CDR880 User Manual

PLAYING
The numbers between parentheses refer to the front fold-out.
Normal playing
1 Press PLAY (13) to start playing (this button may be pressed
when the disc drawer is either open or closed). The relevant track
number and the playing time passed will appear on the display.
-> Press DISPLAY (78) to view the remaining playing time of the
track.
-» Press DISPLAY (78) twice to view the total remaining playing
time of the disc.
"> Press DISPLAY (78) a third time to deactivate the record
indicators (blue and red indicators) on the display. The playing
time passed will once again appear on the display.
"> Press PAUSE (74) to temporarily interrupt playing. Press this
button again to continue playing.
-> Press NEXT (12) to go to the next track.
-» Press PREV (11) to go to the previous track.
-> You can select any track number by pressing the track number
using the number buttons (47) on the remote control. For a two-
digit number, press the two digits in rapid succession.
> Press >> (57) or <€<d (50) to search forward or backward at
twice the playing speed.
ADDITIONAL INFORMATION _
specific display messages
MESSAGE .,....cscscscssssens MEANING
READING.............0000 disc information is being read
OPV aisles laser power calibration in progress
NO DISC iisticecccanseseis no disc present or disc is unreadable
UPDATE answdavcinns the table of contents of the disc is being
updated after a recording
WAR citvarnsimnmntanues the player is performing internal actions
BU cccnstra ttn the program already contains twenty
numbers; if is full
GD FULD sci ciiietess there is no room for additional recording
EVP EY ncscvenaiieaisseesin the disc contains no recordings; it cannot be
finalized
INPUT cinisvesievstocssstiiee, no digital input was selected for CD SYNC
-> Press FAST (56) and then B>B> (57) or << (50) to search
forward or backward at eight times the playing speed.
-> Press REPEAT (67) to repeat the track that is currently
displayed. 'REPEAT 1' (32) will appear on the display.
-> Press REPEAT (67) again to repeat the entire disc or pre-
programmed sequence. 'REPEAT' (32) will appear on the
display.
2 Press STOP (75 or 48) to stop playing.
Programmed play
1 With the CD-Recorder stopped, press PROGRAM (55) on the
remote control.
2 Enter the tracks you want to play using the numeric keys (47).
For 2-digit track numbers, enter both digits in quick succession.
-> You can program up to 20 tracks in any order.
3 To play your program, press PLAY (73 or 59).
-> Tocancel the program, press STOP (75 or 48) twice, or open the
disc.
PINAL seassiotedsiceetenacs OPC has been performed 96 times (maximum
number of calibrations); the disc must be
finalized
RECOVER.............000 recovery procedure performed automatically
after power failure during recording. If this
procedure fails, the CD-R disc - unlike the
CD-RW disc - may no longer be usable
OPCFAIL.................00 OPC has failed; disc is damaged or player is
defect
SERVICE............ccc00000 recorders self-test has failed; see 'Fixing
problems'; contact your supplier
NO AUDIO................... no audio information is available on the disc.
You are trying to record on a CD-R disc that
is not intended for digital audio (see
Introduction, user instructions)