Download Print this page
Electrolux ZC880 Series Owner's Manual
Electrolux ZC880 Series Owner's Manual

Electrolux ZC880 Series Owner's Manual

Heavy duty commercial upright vacuum cleaner

Advertisement

Quick Links

Heavy Duty
Commercial
Upright
Vacuum Cleaner
Owner's Guide
ZC880 Series
Index
Important Safeguards .........................2
Service Information .............................4
Assemble ............................................5
Use ......................................................7
Dust Bag .............................................8
Brush Roll Belt ....................................9
IMPORTANT
Brush Roll..........................................10
Headlight ...........................................11
For any advice and
to order filters and
accessories
on your cleaner,
please telephone
Customer Care
08706 055055
www.electrolux.com

Advertisement

loading

Summary of Contents for Electrolux ZC880 Series

  • Page 1: Table Of Contents

    Heavy Duty Commercial Upright Vacuum Cleaner Owner’s Guide ZC880 Series Index Important Safeguards ......2 Service Information ......4 Assemble ..........5 Use ............7 Dust Bag ..........8 Brush Roll Belt ........9 IMPORTANT Brush Roll..........10 Headlight ...........11 For any advice and to order filters and...
  • Page 2: Important Safeguards

    IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. •...
  • Page 3 MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electrical Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug.
  • Page 4: Service Information

    fit the outlet, have proper outlet installed by a qualified technician. SERVICE Should you require service on your Electrolux cleaner, please telephone 08706 055055. Important - in the event of the mains supply cable of this cleaner requiring replacement, we recommend that this be carried out by a Electrolux Service Agent.
  • Page 5: Assemble

    HOW TO ASSEMBLE CAUTION: Completely assemble vacuum cleaner before using. Assembly Packet is with owner’s guide. 2-Part Lower Bolt Cord Hook Screws Step 1 Attach the Handle Push lower handle into handle socket on the base. Note: Check to be sure slot in handle is positioned correctly, see Detail A.
  • Page 6 Step 2 Attach Lower Cord Hook Make sure cord hook is pointing downwards. Press the power cord into the groove on the cord hook pulling any slack toward the base of the cleaner. On the cord hook, find the curved tab and place in slot on lower handle section, keep cord taut while pressing the cord hook to the left until it snaps...
  • Page 7: Use

    HOW TO USE The upright vacuum cleaner is designed to be used on multiple types of carpeting. Do not attempt to use the upright vacuum cleaner on bare floors, as damage to the floor covering may result. 1. Store 2. Use Handle Adjustment With the tip of the foot, press down to release the handle lock located at the left rear side of...
  • Page 8: Dust Bag

    6. Roll up coil spring. 7. Place paper bag into outer bag. NOTE: Be certain there are no folds at the top or bottom of the paper bag. Ask for GENUINE ELECTROLUX 8. Lift zipper. dust bags–Code E74 Micron Filter Bag Care ®...
  • Page 9: Brush Roll Belt

    Rotate pulley to secure belt into groove. 8. Place slots of bottom plate over tabs of cleaner base. 9. Seat and secure cam locks. Replace Ask for GENUINE ELECTROLUX Phillips® screws. replacement belts - Code ZE096.
  • Page 10: Brush Roll

    When properly assembled, the brush roll should rotate freely between the two end caps. Check the condition of the belt; change if necessary. Replace the brush roll, belt, and bottom plate (see How To Replace A Worn Belt). Ask for GENUINE ELECTROLUX replacement brush strip - Code 506003114002.
  • Page 11: Headlight

    Quick Kleen® Fan Chamber (On some models) NOTE: Turn off the switch and unplug the electrical cord before cleaning. The clear, removable fan chamber cover provides easy inspection, cleaning, and maintenance of the fan chamber. Removing the cover provides easy access to the motor fan.
  • Page 12 The guarantee may be invalidated by unauthorised repair or modification of the appliance. d. You may be charged by Electrolux if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet.