Download Print this page
Sealey ROADSTART RS2000 Manual
Sealey ROADSTART RS2000 Manual

Sealey ROADSTART RS2000 Manual

2000a 12v jump starter power pack

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS &
CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO
SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE
FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1.
SAFETY
1.1.
GENERAL SAFETY
Modern vehicles contain extensive electronic systems.
You are required to check with the vehicle manufacturer, for any specific instructions regarding the use of this type of
equipment on each vehicle. No liability will be accepted for damage / injury, where this product is not used in accordance with
all instructions.
Ensure that the vehicle is in a well ventilated area.
9
Apply the handbrake and select neutral or 'park' before attempting to start.
9
Ensure that the ignition switch and all ancillary electrical equipment is switched off.
9
Keep clear of any pulleys, belts etc. that will move once the engine starts.
9
Take care to ensure correct connection polarity; red clamp to positive, black clamp to negative.
9
Energise the unit only at ambient temperatures between -30°C and 40°C.
9
When not in use, switch off and store in a cool, dry place out of the reach of children.
9
DO NOT allow this power pack to become wet.
8
DO NOT dismantle this unit: there are no user serviceable parts inside.
8
DO NOT use in explosive atmospheres (e.g. the presence of flammable liquids, gases or dust).
8
DO NOT place the product in a high-temperature environment.
8
DO NOT use the unit if it appears damaged in any way.
8
DO NOT use this product for any purpose other than that for which it is designed.
8
DO NOT disassemble or modify the product.
8
DO NOT leave in direct sunlight or expose to heat.
8
DO NOT use abrasive or solvent cleaners on this product.
8
DO NOT allow children or pets to play with this product
8
DO NOT allow the positive and negative clamps to touch.
8
DO NOT connect both cable clamps to the same piece of metal.
8
DO NOT abuse the product. Handle with care.
8
1.2.
BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°).
8
DO NOT use the product to start a bulging car battery.
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
8
water and seek immediate medical attention.
2.
INTRODUCTION
Easily fits in a glove box or backpack and benefits from being compact and lightweight. Powered by lithium-ion technology and fully
protected against short circuit, overload and reverse polarity. Fitted with a 20,000mAh lithium-ion battery and two USB Type A outlets
(5V/3A, 9V/2A,12V/1.5A), Type-C input and output leads (5V/3A, 9V/3A, 12V/3A, 15V/3A, 20V/2.25A) and DC output 15V/10A this
unit can also supply several full charges for smartphones and tablets/laptops. Capable of starting an average 10L petrol or 8L diesel
engine. Integral LED flashlight with multiple settings (Solid, SOS, Flash). Supplied in a sturdy hard-shell zip-up case with battery
clamps and 2x USB cables.
3.
SPECIFICATION
Model No: .......................................................... RS2000
Cable & Clamp Length: ....................................... 430mm
Capacity: ..........................20Ah @ 3.7V or 5Ah @ 14.8V
Maximum Current:............2000A Peak, 1000A Cranking.
© Jack Sealey Limited
ROADSTART® 2000A 12V JUMP STARTER
POWER PACK
MODEL NO:
Wear protective
WARNING!
gloves
Electricity
Original Language Version
RS2000
Keep in dry
Warning
area. Protect
corrosive
from rain
substance
Maximum Starting Capacity: ........... 10L Petrol/8L Diesel
Size (W x D x H): ............................... 113 x 66 x 243mm
Voltage: .....................................................................12V
Keep away
Use in well
from sources of
ventilated
ignition
areas
RS2000
Issue 2 (H)
WARNING!
Explosive
material
19/09/23

Advertisement

loading

Summary of Contents for Sealey ROADSTART RS2000

  • Page 1 RS2000 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS &...
  • Page 2 Check the battery level at least once every six months and charge the product in time. 5.2. CLEANING DO NOT use detergents to clean the product. Clean with a soft cloth. RS2000 Issue 2 (H) 19/09/23 Original Language Version © Jack Sealey Limited...
  • Page 3 BATTERY REMOVAL Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.