Whirlpool ADG 934 Manual

GB ADG 934
Important:
• If a fault occurs or you wish to change the current programme, press
the "START" button for about 5 seconds until the Start indicator lamp
switches off ! Refer to the "Troubleshooting guide" in these user
instructions to remedy any problems.
• Switch off the dishwasher once the "Start" indicator lamp has
switched off. If you switch off the dishwasher during a wash cycle,
when switched on again the dishwasher resumes the cycle from where
it was interrupted.
Start button indicator lamp:
Switches "on" when the dishwasher is
operating.
Flashes when a fault occurs.
Switches "off" at the end of the programme.
Programme selector
0 = Off.
Programme
Symbol
Crockery to be washed later.
Pre-rinse
Lightly soiled crockery with no dried-on food.
Rapid 50 °C
Normally or heavily soiled crockery.
Normal 65 °C 1)
*) Recommended programme for use with "new generation" enzyme-based detergents.
**) For pre-rinse.
***) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.
1) Check the programme on the energy data plate.
PROGRAMME CHART
Programme progress indicators
Pre-rinse
Washing
Drying
Programme end
Load
Crockery and cutlery
Detergent dispenser:
Final rinse
+) with pre-rinse
temperature:
-) without pre-rinse
** small large
compartment compartment
- - -
55 °C - +
65 °C + +
Consumption ***
Normal load
Water Energy Time
(Liter) (kWh) (Min.)
5.0 0.02 9
12.5 0.90 65
22.0 1.64 93
5019 100 91058