Table of Contents
Advertisement
en Wireless cooking sensor
Chips
15.3 Wireless cooking sensor
To use PerfectCook Sensor, you must purchase a wire-
less cooking sensor.
You can purchase the wireless cooking sensor from
customer service, in our online shop or in a specialist
shop www.bosch-home.com.
Connecting the wireless cooking sensor
To connect the wireless cooking sensor to the control
panel, proceed as follows:
Opening the basic settings → Page 21
1.
Select the cooking sensor setting and select the
2.
"Add new cooking sensor" option.
Briefly touch the centre of the wireless cooking
3.
sensor within 30 seconds.
After a few seconds, the result of the connection
‒
between the cooking sensor and the control
panel appears on the display.
Result
Connected
PerfectCook Sensor is available.
correctly
Not con-
Communication error
nected cor-
¡ Repeat the connection process.
rectly
If the result is still , contact
customer service.
Wireless cooking sensor
16 Wireless cooking sensor
To use PerfectCook Sensor, you must purchase a wire-
less cooking sensor.
You can purchase the wireless cooking sensor from
customer service, in our online shop or in a specialist
shop www.bosch-home.com.
16.1 Scope of delivery
After unpacking all of the parts, check for any transport
damage and for completeness of delivery.
Wireless cooking sensor
¡
Silicone patch
¡
18
180
4-8
Result
Not con-
Communication error
nected cor-
¡ Bluetooth communication error.
rectly
Repeat the connection process.
¡ You have not touched the
centre of the wireless cooking
sensor within 30 seconds of se-
lecting the cooking zone. Re-
peat the connection process.
¡ The battery in the wireless
cooking sensor is flat. Replace
the battery, reset the wireless
cooking sensor and repeat the
connection process.
Resetting the wireless cooking sensor
Press the centre of the cooking sensor for approx. 8
1.
- 10 seconds.
a During this process, the LED display for the wireless
cooking sensor lights up three times.
a When the LED lights up for the third time, it will start
to reset the temperature sensor.
Now stop pressing the centre of the wireless cook-
2.
ing sensor.
a As soon as the LED goes out, this means that the
wireless cooking sensor has been reset.
Repeat the connection process from point 2.
3.
Setting the boiling point
The point at which water starts to boil depends on the
height of your home above sea level. If the water is
boiling too vigorously or not vigorously enough, you
can adjust the boiling point. Proceed as follows:
Select the "Set boiling point" setting in
→ "Basic settings", Page 21.
The default basic setting is 200–400 m. If the home is
located at this height above sea level, do not set the
boiling point. Select the setting that matches your
home's height above sea level.
Note: The temperature 3/100 ºC is sufficient to boil ef-
ficiently. For a more intensive boil, select a lower level.
Template
¡
16.2 Attaching the silicone patch
The silicone patch secures the cooking sensor to the
cookware. For fitting on the cookware:
Advertisement
Table of Contents
