Philips DSR7000 User Manual page 23

Ch1_Connecting_DTV3.1.r1.fm Page 15 Wednesday, March 5, 2003 4:22 PM
Example 2: DVR with VCR
Connect the coaxial RF cables from your satellite dish antenna to the DIRECTV DVR.
Connect one coaxial RF cable that comes from your satellite dish antenna to the jack
labeled "Satellite In 1" on the DVR. If you have a second coaxial RF cable from your
satellite dish antenna, connect it to the jack labeled "Satellite In 2."
Connect the DVR to your TV. Look at the back of your TV and see what types of jacks
are available. Connect the DVR's output to the TV's input using the best connection
available. The example in the diagram shows a composite cable connected for audio and
an S-Video cable connected for video. The connection can also be made using only a RF
coaxial cable, or using only a composite cable.
Connect the DVR to your VCR. Connecting the DVR to your VCR will allow you to
save programs recorded on your DIRECTV DVR to videotape. The example in the
diagram shows an RF cable running from the DVR's output to the VCR's input.
Connect your VCR's output to your TV's input. This will allow you to watch
videotapes. The example in the diagram shows an RF cable running from the VCR's
output to the TV's input.
Connect the phone line. (For more about the phone connection, see page 3.)
Insert the Access Card that came with your DVR. Insert the card into the slot in the
direction indicated on the card. Stop when the card makes contact with the back of the
®
slot. To watch DIRECTV
(activation is covered in the next chapter).
Plug in all power cords. After you see the Welcome screen, skip to "Guided Setup" on
page 23. If you do not see the Welcome screen, see page 119.
channels, you must insert the card correctly and activate it
S e t u p E x a m p l e s
1
15