ENGLISH Introduction Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. Accessory The following accessory is included. AC Power Lead x 1...
MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson. The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by SHARP is under license. Other trademarks and trade names are those of their respective owners. Warnings: Note: ●...
SHARP recommends that the fi rst few times it is used. Do not expose the only qualifi ed professionals remove the battery, battery to extreme temperatures, never above 40°C (104°F) or below 5°C (41°F).
40°C (104°F) or below 5°C - 40°C (41°F - 104°F). 5°C (41°F). ● SHARP are not responsible for damage due to ● If the unit does not work properly, unplug and improper use. Refer all servicing to a SHARP plug it in again.
When the battery charge is low, ‘beep’ sound is heard and the battery indicator will be blinking. WARNING: Do not attempt to change or replace the battery. This can only be carried out by a qualifi ed technician. PS-955 _smef_EN_CS4.indd 6 PS-955 _smef_EN_CS4.indd 6 2023-08-04 17:49:40...
● Do not unplug the USB drive from the unit when recording is in progress. LIGHTS OUT PRISM CLUB Press and hold the LIGHT button to switch the strobe light on or off. PS-955 _smef_EN_CS4.indd 7 PS-955 _smef_EN_CS4.indd 7 2023-08-04 17:49:40 2023-08-04 17:49:40...
USB playback Turn on the Bluetooth function on the source device, scan the unit “PS-955 SHARP” and Press the INPUT button repeatedly on the unit connect, then input the password 0000 if to select USB mode.
Control the playback with your audio device. Line in/out operation Use the RCA cable to connect your device to the LINE IN / OUT terminals at the rear panel. Control the playback with your audio device. PS-955 _smef_EN_CS4.indd 9 PS-955 _smef_EN_CS4.indd 9 2023-08-04 17:49:41 2023-08-04 17:49:41...
● Do not apply oil to the inside of each component. interrupted or electromagnetic radiation. It may cause malfunctions. distorted. ● There is an obstacle between the unit and the Bluetooth audio source device. E-10 PS-955 _smef_EN_CS4.indd 10 PS-955 _smef_EN_CS4.indd 10 2023-08-04 17:49:41 2023-08-04 17:49:41...
Specifi cation As part of our policy of continuous improvement, SHARP reserves the right to make design and specifi cation changes for product improvement without prior notice. The performance specifi cation fi gures indicated are nominal values of production units. There may be some deviations from these values in individual unit.
Page 13
Cet appareil doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps. Cet transmetteur ne doit pas être cositué ou opérant en liaison avec toute autre antenne ou transmetteur. PS-955 _smef_EN_CS4.indd 11 PS-955 _smef_EN_CS4.indd 11 2023-08-04 17:49:41...
Page 14
L’exploitation est autorisée aux deux conditions suivantes : (1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. PS-955 _smef_EN_CS4.indd 11 PS-955 _smef_EN_CS4.indd 11 2023-08-04 17:49:41 2023-08-04 17:49:41...