Table of Contents
Advertisement
4-6.
Front Panel Assembly
Preparation
1.
Remove the side panel (L), side panel (R) and bottom cover. (Refer to
2.
Remove the DPR-376 board. (Refer to
Procedure
1.
Remove the front assembly.
(1) Disconnect the harness from the connector (CN003) on the SY-449 board, and release the harness from the
clamper.
(2) Disconnect the harness from the connector (CN005) on the PS-921 board.
(3) Remove the two screws (B3 x 10), and then draw the front panel assembly in the direction of the arrow.
(4) Disconnect the harness from the connector (CN010) on the PS-921 board, and release the harness (CIS-PWR)
from the clamper, and then remove the peel off the tape AS.
(5) Remove the front panel assembly.
Front panel assembly
B3 x 10
2.
Install the removed parts by reversing the steps of removal.
HDC-P43
"4-5. DPR-376
Board")
CN003
Clamper
CN005
Clamper
"4-4. Side Panel, Bottom
Cover")
Harness
Harness (front)
SY-449 board
Tape AS
PS-921 board
Rear panel assembly
CN010
Harness (CIS-PWR)
4-11
Advertisement
Table of Contents
