Appendix; Display Messages; List Of Supported Characters - Yamaha ACD1 Reference Manual

Appendix

Display messages

Messages that may appear in the ACD1's display and the appropriate responses are listed below. For more about
alert messages, refer to the Amp Editor owner's manual.
Message
Panel locked!
Parameter
locked!
Unlock panel:
Are you sure ?
Scene storing
Do not turn off!
Cannot edit
while online!
Scene protected!
File writing
Do not turn off!
Initializing
Do not turn off!
Updating f/ware
Do not turn off!
Synchronizing
Do not turn off!
System error
Saving failed
Flash ROM error
Network HW error
Illegal MAC adr
Scene recall err
Current scn lost
No battery
Critical battery
Low battery
Duplicate IP adr
Amp comm error

List of supported characters

The ACD1 allows the following single-byte characters to be displayed and input.
Uppercase alphabet
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Lowercase alphabet
a b c d e f g h i j k l m n o p q r s t u v w x y z
Numerals
0 1 2 3 4 5 6 7 8 9
Symbols
! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` {
To prevent unintended operation, panel operations have been locked by the Panel Operation setting.
To temporarily defeat Panel Operation, hold down both the [▲INC/YES] / [▼DEC/NO] buttons for at
least three seconds. To turn Panel Lock off, first defeat it temporarily, and then change the "5.Utility" ➝
"Panel Operation" setting to Normal.
To prevent unintended operation, parameter editing has been locked by the Panel Operation setting.
To temporarily defeat Panel Operation, hold down both the [▲INC/YES] / [▼DEC/NO] buttons for at
least three seconds. To turn Panel Lock off, first defeat it temporarily, and then change the "5.Utility" ➝
"Panel Operation" setting to Normal.
This is displayed when you temporarily defeat User Lock.
To defeat the setting, press the [▲INC/YES] button.
A scene is being stored. Never turn off the power while this message is shown.
Settings cannot be edited, because the unit is online with Amp Editor.
You cannot store to a protected scene.
A file is being written to internal memory. Never turn off the power while this message is shown.
Internal memory is being initialized. Never turn off the power while this message is shown.
The firmware is being updated. Never turn off the power while this message is shown.
Now synchronizing with Amp Editor. Never turn off the power while this message is shown.
Initialize the memory. If this does not solve the problem, contact your Yamaha dealer.
It is likely that the device has malfunctioned; please contact your Yamaha dealer.
The backup battery may have run down. Contact your Yamaha dealer.
When you turn off the power, the current settings will be lost, and will return to the default values.
Immediately stop using the unit, and contact your Yamaha dealer.
If you continue operation, settings may be lost and return to the default values. Contact your Yamaha
dealer as soon as possible.
Re-specify the IP addresses so that they do not conflict.
Make sure that each of the connected amplifiers has a unique ID. Alternatively, a cable may be short-
circuited or noise may be affecting the connection.
Response
}
(Space)
21
ACD1 Reference Manual