GETTING STARTED
Never plug the AC power cord into the wall outlet until all connections are
completed.
Follow the steps as shown below to connect the system using the supplied cables and accessories.
Right speaker
NX-TS20
NX-TS10
1
Connecting speakers
Connect the speakers to the SPEAKERS terminals of the main unit by using the speaker cables. Make sure that the
polarity of the speaker cables is correct, i.e. the + and – markings are observed. If these cables are reversed, the sound will
be unnatural and lack bass.
On the main unit
On the speakers
(NX-TS10)
6
Connections
Indoor
FM antenna
3
To wall outlet
Red: positive (+)
Black: negative (–)
1 Press the tab.
2 Remove approx. 10 mm
(3/8") of insulation from
each of the speaker
cables and insert the bare
wire into the terminal.
3 Release the tab and
secure the cable.
AM loop antenna
2
OPTICAL
CD DIGITAL OUT
4Ω MIN. /SPEAKER
FOR USA : CLASS 2 WIRING
SPEAKERS
SETTING
SUBWOOFER
ANTENNA
FM 75 Ω UNBAL.
HRIZ
OTHER
OUT
B
1
On the speakers (NX-TS20)
Red: positive (+)
Black: negative (–)
Loosen
Caution
Do not let the bare speaker wires touch each
other as this could damage the main unit and/or
speakers.
Left speaker
A
OUT
IN
LINE
GND
AM
1 Unscrew the knob.
2 Remove approx. 10 mm
(3/8") of insulation from
each of the speaker
cables and insert the bare
Tighten
wire into the terminal.
3 Tighten the knob to
secure the cable.
NX-TS20
NX-TS10