Yamaha CL1 Owner's Manual page 28

❏ TO STEREO/MONO
Here you can specify how the signal will be sent from the input channel to the STEREO bus/MONO bus.
MODE
• ST/MONO button
When this button is on, the signal will be sent to the STEREO L/R bus and independently to the MONO bus.
[INPUT CH 1–72]
PAN
(PAN/BALANCE for ST IN)
ST
M(C)
• LCR button
When this button is on, the signal will be sent to the L/C/R buses which work in conjunction with each other.
[INPUT CH 1–72]
PAN
(PAN/BALANCE for ST IN)
CSR (Center Side Ratio)
The PAN knob adjusts the panning of the signal sent from the input channel to the STE-
REO bus L/R channels. You can set this to the center position by holding down the
<Ctrl>(< >) key of the computer keyboard and clicking the knob. You can select Pan or
Balance for ST IN. The BALANCE knob adjusts the balance of the signal that is sent from
the ST IN channel to the STEREO bus L/R channels. PAN/BALANCE can be switched
with the [PAN]/[BALANCE] buttons.
Switches the signal sent from the input channel to the STEREO bus on/off.
Switches the signal sent from the input channel to the MONO bus on/off.
The PAN knob adjusts the panning of the signal that is sent from the input channel to each
of the L/C/R channels. You can set this to the center position by holding down the
<Ctrl>(< >) key of the computer keyboard and clicking the knob. You can select Pan or
Balance for ST IN. The BALANCE knob adjusts the balance of the signal that is sent from
the ST IN channel to the STEREO bus L/R channels. PAN/BALANCE can be switched
with the [PAN]/[BALANCE] buttons.
Adjusts the proportion of the CENTER channel level relative to the STEREO bus L/R in a
range of 0–100%.
28
[ST IN channel 1–8]
[ST IN channel 1–8]
CL Editor Owner's Manual