Fitting A Door Front Panel Made By Another Manufacturer; Preparing The Front Panel - Miele W 2209I Operating Instructions Manual

Installation and connection
Fitting a door front panel made
by another manufacturer

Preparing the front panel

A Measure distance X for drilling the
hinge holes.
– with spacer bars:
– without spacer bars:
(the front panel must be
correspondingly higher)
54
B Mark the two hinge holes and the
four smaller holes as shown in the
diagram.
For left hand hinging only:
– front panel shown decor side face
down, upper edge at the bottom:
if width (b) increases, measurement a
must also be increased
b = 592 mm N a = 21.5 mm
b = 593 mm N a = 22.0 mm
b = 594 mm N a = 22.5 mm
b = 595 mm N a = 23.0 mm
b = 596 mm N a = 23.5 mm
The height H of the door front panel
corresponds to the door height of the
adjacent units.