Installing Batteries - Motorola DCT700 User Manual

USING THE REMOTE CONTROL
9

Installing Batteries

Before you can use the remote control, you must install
two AA (1.5-volt) alkaline batteries (provided with your
Motorola universal remote control):
1. Slide open the battery door on the back of the
remote control.
2. Insert the batteries in the direction indicated on the
inside of the battery compartment.
Batteries installed incorrectly can cause battery leakage
and corrosion that will damage the remote control.
3. Slide the battery door closed until it snaps into place.
Point the remote control at the DCT700, and then press
POWER. If the DCT700 does not turn on, check the
orientation of the batteries or replace with new batteries.
Your remote control may be different from the Motorola
DRC450 Universal Remote Control illustrated here. Refer
to the remote control User Guide for details on installing
batteries.