Connecting An Av Receiver Or Amplifier Using Audio; Cables; Connecting Components To The Usb Port; About Usb (External Storage) Devices - Pioneer BDP 320 - Blu-Ray Disc Player Operating Instructions Manual

video deck. Furthermore, the picture may not be
displayed properly due to the copy protection when
the player is connected to a TV with a built-in video
deck. For details, contact the manufacturer of your
TV.
Player's rear panel
VIDEO VIDEO COMPONENT VIDEO COMPONENT VIDEO
Yellow OUT OUT Y Y
VIDEO VIDEO
P P
L L
White
R R P P
Red
FRONT FRONT
CONTROL CONTROL
IN IN AUDIO OUT(7.1 ch) AUDIO OUT(7.1 ch)
It is also possible to connect to
an AV receiver or amplifier.
Connect the audio signals
using audio cables (7.1
channels) or an optical digital
audio cable (below).
TV
To video/audio
input terminals
Note
• Video signals are output with a resolution of 480/60i
when connected using a video cable.
• When connected to the TV using a component video
cable, video signals are not output with a resolution of
1080/24p or 1080/60p.
• Depending on the output video resolution setting, the
picture may not be output (page 22).
Connecting an AV receiver or
amplifier using audio cables
When connecting to a 7.1-channel compatible AV
receiver or amplifier – Connect using 4 audio cables
(diagram below).
When connecting to a 5.1-channel compatible AV
receiver or amplifier – Connect using 3 audio cables (do
not connect to the surround back left and right
terminals).
• To switch the video from the AV receiver or amplifier,
also connect the video output terminals.
• After connecting, set Audio Output Mode to Multi-
channel (page 38).
CENTER CENTER SUB WOOFER SUB WOOFER
B B
L L
R R
R R
SURROUND SURROUND SURROUND SURROUND
BACK BACK
A component
cable or three
commercially
available video
cables can be
used instead of
the video cable
(yellow plug) of
the included
video/audio cable
for connection.
To component
video input terminals
Direction of signal flow
Player's rear panel
VIDEO
COMPONENT VIDEO CENTER
Y
OUT
VIDEO
P
DIGITAL L B
OUT
R P R
FRONT SURROUND
CONTROL
OPTICAL
IN AUDIO OUT(7.1 ch)
To optical digital
audio input
AV receiver or
terminal
amplifier
Note
• To connect to the 2-channel audio input terminals on
a TV, etc., connect to FRONT (L/R).
Connecting components
to the USB port
The data downloaded with the BD-LIVE function and the
data used with the BONUSVIEW function when playing
BD-ROMs can be stored on a device connected to the
USB port (external storage).
About USB (external storage)
devices
The USB (external storage) devices that can be
connected to the player are as shown below.
• USB 2.0-compatible memory devices or hard disks
• FAT16 or FAT32 file system, minimum 1 GB capacity
(2 GB or more recommended)
Note
• Devices formatted with a file system other than the
above cannot be used. Such devices may however be
usable if they are formatted from the player.
• External storage devices may not be recognized if
they contain multiple partitions.
• Some external storage devices may not operate with
this player.
• Operation of external storage devices (USB memory
devices, external hard disks, etc.) is not guaranteed.
SUB WOOFER
L
R
SURROUND
BACK
To multi-channel audio
input terminals
Direction of signal flow
02
17
En