Configure DSL Signaling Protocol
Command
Step 5
no shutdown
Example:
Router(config-if-atm-vc)# no shutdown
Router(config-if)#
Step 6
exit
Example:
Router(config-if)# exit
Router(config)#
Configure DSL Signaling Protocol
DSL signaling must be configured on the ATM interface for connection to your ISP. The
Cisco Secure Router 520 ADSL-over-POTS routers support ADSL signaling over POTS and the
Cisco Secure Router 520 ADSL-over-ISDN routers support ADSL signaling over ISDN. To configure
the DSL signaling protocol, see the
Configuring ADSL
The default configuration for ADSL signaling is shown in
Table 4-1
Attribute
Operating mode
Loss of margin
Training log
If you wish to change any of these settings, use one of the following commands in global configuration
mode:
•
•
•
See the Cisco IOS Wide-Area Networking Command Reference for details of these commands.
Cisco Secure Router 520 Series Software Configuration Guide
4-6
Default ADSL Configuration
Description
Specifies the operating mode of the digital subscriber line
(DSL) for an ATM interface.
ADSL over POTS—ANSI or ITU full rate, or
•
automatic selection.
ADSL over ISDN—ITU full rate, ETSI, or
•
automatic selection.
Specifies the number of times a loss of margin may occur. —
Toggles between enabling the training log and disabling the
training log.
dsl operating-mode (from the ATM interface configuration mode)
dsl lom integer
dsl enable-training-log
Purpose
Enables interface and configuration changes just
made to the ATM interface.
Exits configuration mode for the ATM interface.
"Configuring ADSL" section on page
Table
Chapter 4
Configuring PPP over ATM with NAT
4-6.
4-1.
Default Value
Auto
Disabled
OL-14210-01