Overview
Overview
Browser and System Support
Enabling Web Management
Cisco 11000 Series Secure Content Accelerator Configuration Guide
5-2
While most configuration options are available with the GUI, you must be aware
of the following constraints:
•
The Secure Content Accelerator must have an IP address assigned before
connecting with the GUI; use serial configuration to set the appliance IP
information.
The GUI cannot be used to set the SSL appliance to single-port operation.
•
Web management must be enabled. See the command web-mgmt in
•
Appendix C.
The GUI has the following requirements:
•
Color recommendations—The minimum display resolution required is
SVGA (800x600 resolution). For best results, use XGA (1024x768
resolution).
Browser Support—The GUI requires Microsoft® Internet Explorer version
•
5.x or later, or Netscape® Navigator 4.77 or 6.x or later.
Web management is disabled by default. To view the state of Web management,
enter the show device CLI command. Web management status is shown in the
returned listing as follows:
...
Web Management:
disabled
...
Enter Privileged and Configuration modes and enable Web management using
these commands:
enable
configure
web-mgmt enable
Chapter 5
Graphical User Interface Reference
78-13124-06