Cisco RV042 - Small Business Dual WAN VPN Router User Manual page 62

Chapter 4
5. For this service, you can select whether or not you want
the Router to keep a log tracking this type of activity.
To keep a log, select Log packets match this rule. If
you do not want a log, select Not log.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
Select the Log Rule
6. Select the Source Interface:
Any from the Interface pull-down menu.
Select the Source IP address(es) for this Access Rule. If it
can be any IP address, select Any. If it is one IP address,
select Single and enter the IP address. If it is a range
of IP addresses, select Range, and enter the range of
IP addresses.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
Select the Source
10/100 4-Port VPN Router
LAN, WAN1, WAN2, or
Advanced Configuration
7. Select the Destination IP address(es) for this Access
Rule. If it can be any IP address, select Any. If it is one
IP address, select Single and enter the IP address. If it
is a range of IP addresses, select Range, and enter the
range of IP addresses.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
Select the Destination
8. Decide when you want this Access Rule to be enforced.
Select Always if you want the Access Rule to be always
enforced, or select Scheduling if you want to specify
when the Access Rule should be in effect.
When It Works
If you selected Always, click Next to continue. Click
Previous if you want to return to the previous
screen. Click Exit if you want to exit the Setup Wizard.
If you selected Scheduling, click Next to continue. A
new screen appears. Decide what times and which
days of the week the Access Rule should be enforced.
Then enter the hours and minutes in 24-hour format,
and select the appropriate days of the week. Click
55