Table of Contents
Advertisement
Two Satellite Receivers
You must have two identical satellite receivers from the
same source and the HP Digital Entertainment Center
dual-tuner option (select models only) to set this up. This
configuration will allow you to watch live TV on one
channel and record another channel at the same time.
Connect the TV signal source from each satellite receiver
into each HP Digital Entertainment Center tuner.
If you are using two matching satellite receivers with
S-video or composite video output, do the following:
1
Make sure that a coaxial cable connector from your
dish source is plugged into two cable outputs, and
each satellite receiver In connector.
2
Connect a video cable for satellite receiver 1:
a
Choose a Video Out connector:
Video (composite)
■
S-video
■
b
Connect the video cable from the
satellite receiver back panel video output
connector.
c
Connect the video cable into the HP Digital
Entertainment Center back panel TV Source 1 In
connector.
3
Connect stereo audio cables for satellite receiver 1
(skip this step if using coaxial [RF]):
a
From the satellite receiver back panel Audio Out
right (red) connector and the Audio Out left
(white) connectors.
b
Into the HP Digital Entertainment Center back
panel TV Source 1 In Audio right (red) and Audio
left (white) connectors.
88
HP Digital Entertainment Center
4
Connect a video cable for satellite receiver 2:
a
Choose a video out connector, use the same type
as satellite receiver 1:
Video (composite)
■
S-video
■
b
Connect the video cable from the
satellite receiver back panel video output
connector.
c
Connect the video cable into the HP Digital
Entertainment Center back panel TV Source 2 In
connector.
5
Connect stereo audio cables for satellite receiver 2
(skip this step if using coaxial [RF]):
a
From the satellite receiver back panel Audio Out
right (red) connector and Audio Out left (white)
connectors.
b
Into the HP Digital Entertainment Center back
panel TV Source 2 In Audio right (red) and Audio
left (white) connectors.
6
Connect the satellite receiver 1 Infrared Transmitter
cable (required for signal). See "Infrared Transmitter
Connection" on page 90.
7
Connect the satellite receiver 2 Infrared Transmitter
cable (required for signal). See "Infrared Transmitter
Connection" on page 90.
Advertisement
Table of Contents
