LG DLE9577SM Owner's Manual page 12

Part 3 INITIAL STEPS FOR INSTALLING YOUR DRYER
Assemble
Put the hooks of the panel into the left side holes of
3
frame correctly.
Next the surface of the A is located in the higher
place than the surface of the B.
Then, Push the panel until it is aligned three holes
on the top of the frame.
Attach the panel by sliding to the left in
4
clicks into place.
Turn the screw to the right.
Close the cap.
!
WARNING!
Be sure the screw is properly tightened.
If it isn't, the control panel could come off.
Control Panel
5
Attach the safety cover.
!
WARNING!
Be sure to install the safety cover to
avoid electric shock.
Safety Cover
1 0
B
A
Frame
Cap
Attach the lower cover in the upper
6
position where the control panel was
removed.
Tighten the screw.
Push the cap.
!
WARNING!
Be sure the screw is properly tightened.
If it isn't the lower cover could come off.
Install the hooks of the plate in the holes
7
of the frame.
8
Slide the plate to the left until it clicks into
place.
Note
LG is not responsible for any damages to your
dryer incurred while a customer is changing.
Cap