Table of Contents
Advertisement
10. INSTALLING THE ANTI-TIP DEVICE
WARNING
• Range must be secured with an approved
Anti-Tip device.
• Unless properly installed, the range could
be tipped by you or a child standing, sitting
or leaning on an open door.
• After installing the Anti-Tip device, verify
that it is in place by carefully attempting to
tilt the range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The installation of the Anti-Tip device must
meet all local codes for securing the
appliance.
• The use of this device does not preclude
tipping of the range when not properly
installed.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device MBM34391101.
A
Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for
the countertop overhang if you intend to
install the range next to cabinets.
B
Locate the outside edge of the device
" toward the center of the range from the
2
1
⁄
8
marked edge of the range.
I N S TA L L AT I O N I N S T RU C T I O N S
Using the device as a template, mark the
C
position of the hole for the screw.
D
For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal. A
nail or awl may be used if a drill is not
available.
E
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, you will
need a 1/4" x 1
sleeve anchor, which are not provided. Drill the
recommended size hole for the hardware.
Install the sleeve anchor into the drilled hole and
then install the lag bolt through the device. The
bolts must be properly tightened as
recommended for the hardware.
F
Slide the range against the wall, and check
for proper installation by grasping the front
edge of the cooktop and carefully
attempting to tilt the range forward.
" lag bolt and a 1/2" O.D.
1
⁄
2
13
Hide quick links:
Advertisement
Table of Contents
