Configuring Idrac Networking Using The Web-Based Interface - Dell POWEREDGE M1000E Configuration Manual

1 Log in to the Web-based interface. See "Logging in to the CMC Using the
Web-Based Interface" on page 31.
2 Select Chassis in the system tree.
3 Click the Network/Security tab, and then click the Users sub-tab. The
Users page appears, listing each user's user ID, login state, user name, and
CMC privilege, including those of the root user. User IDs available for
configuration have no user information displayed.
4 Click an available user ID number. The User Configuration page is
displayed.
To refresh the contents of the Users page, click Refresh. To print the
contents of the Users page, click Print.
5 Select general settings for the users.
For details on user groups and privileges, see "Adding and Configuring
Users" in the CMC User's Guide.
6 Assign the user to a CMC user group.
When you select a user privilege setting from the CMC Group drop-down
menu, the enabled privileges (shown as checked boxes in the list) are
displayed according to the pre-defined settings for that group.
You can customize the privileges settings for the user by using the check
boxes. After you have selected a CMC Group or made Custom user
privilege selections, click Apply Changes to save the settings.

Configuring iDRAC Networking Using the Web-Based Interface

Follow this procedure if you did not configure the iDRAC in the LCD
Configuration Wizard.
NOTE:
If you did not configure the iDRAC using the LCD Configuration Wizard, the
iDRAC is disabled until you configure it using the Web-based interface
NOTE:
You must have Chassis Configuration Administrator privileges to set up
iDRAC network settings from the CMC.
NOTE:
The default CMC user name is root and the default password is calvin.
1 Log in to the Web-based interface. See "Logging in to the CMC Using the
Web-Based Interface" on page 31.
Initial System Configuration
33