Advertisement
Select Options from the View pull-down menu.
2.
Click on the "Auto Dial" tab on the Options window.
3.
Uncheck the "Use Autodial" check box.
4.
Click OK.
5.
Close WorldTALK and do a soft reset of the MobilePro.
6.
Printing With bPrint Software
One advantage of the bFax software on your MobilePro 790 is the ability to print faxes through
the infrared port at the 115.2Kbps setting, using bFax's bPrint software. Infrared is the only
supported printing device. If you do not have a printer that supports Infrared printing, you can
place the file you wish to print on your desktop or notebook computer and print through your
default printing device.
Follow these steps to change your Infrared printer port setting:
Tap Start, Settings, Control Panel.
1.
Tap on MobilePro Settings icon.
2.
Use the arrow buttons to access the IrDA tab.
3.
Select 115.2Kbps.
4.
Tap the OK button, then Tap OK again.
5.
Save all your data and soft reset the system.
6.
AC Adapter Cable Storage
In order to ensure the proper operation of your AC adapter cable, and to avoid damaging the
adapter, NEC recommends that you not bend the AC cable more than 60 degrees where it
connects to the adapter. When storing your AC adapter, use a large enough container that the
cable does not bend more than 60 degrees.
Disconnecting During ActiveSync Synchronization
When copying files from your MobilePro to your PC using ActiveSync, do not
turn off your MobilePro or PC.
!
remove the serial cable from the serial port of either system.
!
double tap the connection icon in the status area of the task bar and tap the [Disconnect]
!
button.
In the event your serial cable should accidentally disconnect from the MobilePro or the PC
during synchronization, you may experience difficulty getting a connection between the two
systems. If this happens, if may be necessary to soft reset your MobilePro to restore it to proper
operation. Please refer to your user's guide for instructions on resetting the MobilePro.
2 NEC MobilePro 790 Release Notes
Advertisement
