NEC VERSA 4000 BATTERY CHARGER WITH AC ADAPTER Manual page 2

Inserting A Battery Pack
2 NEC Versa 4000 Series Battery Charger with AC Adapter
See "Reading the LEDs" and "Reading the Fuel Gauge" later in this sheet to locate
4.
the battery charger LEDs.
Once connected to the AC adapter, the battery charger LEDs run through a brief di-
agnostic test as follows:
!"
both status LEDs flash green, yellow, then red
!"
each fuel gauge LED lights green sequentially, then dims.
When the bay 1 status LED displays a continuous flashing yellow light, the diag-
nostic test is completed and the battery charger is ready for use. The bay 1 status
LED flashes yellow until a battery pack is inserted into bay 1 or bay 2.
Once the AC adapter is connected, insert a battery pack into your battery charger as
follows.
NOTE
The NEC Versa 4000 Series battery charger only charges the
Li-Ion battery specified.
Position the battery pack so that the battery terminals face down, and the battery
1.
label faces left. See the following figure.
Inserting a Battery Pack