Setting & Displaying The Date & Time - JVC BD-X200U - Dvd Authoring Recorder Instructions Manual

Setting & Displaying the Date & Time
Use the following procedure to set the internal clock's date and time. Even when the DVD recorder's power is turned off, the clock's
date and time settings are stored using the internal battery.
Note that these settings are used to write the current date and time to a disc being finalized.
The DISPLAY screen can be used to indicate whether or not the date and time are to be displayed on-screen.
Setup Menu
DISC MENU
INPUT SELECT
SYSTEM
PRESET STYLE
RECORDER
REMOTE
DISPLAY
CLOCK ADJUST
DUBBING
NETWORK
EXIT
CLOCK ADJUST MENU screen
CLOCK ADJUST MENU
MENU
DATE
TIME
CLOCK ADJUST MENU
MENU
DATE
TIME
CLOCK SETTING
07 : 44
07 44
OPERATE
AUDIO
CH1
DOLBY DIGITAL
LPCM MPEG
CH2
PHONES REV STOP
Setting the Date and Time
Setting of the date and time is carried out using the CLOCK ADJUST MENU
screen. During this procedure, the monitor connected to the VIDEO LINE OUT
terminal is used to monitor the setting of data.
1.
2.
3.
04/05/04
10:00
04/05/04
12:00
4.
5.
SET
DVD RECORDER BD-X200
TITLE CHAPTER
PLAY FWD PAUSE REC TOP
MENU
Turn on the power and ensure that the DVD recorder is stopped.
Press the SET UP button to display the Setup Menu.
Open the CLOCK ADJUST MENU screen.
q Use the 6 and 7 buttons to select CLOCK ADJUST. (The currently
selected menu item is displayed as highlighted.)
w Press the SET button to open the CLOCK ADJUST MENU screen.
Set the date and time as required.
q Use the 6 and 7 buttons to select either DATE or TIME. Then press the
SET button.
w Use the t and 8 buttons to select the digit to be changed. (The currently
selected digit is displayed as highlighted text.)
e Use the 6 and 7 buttons to change the value of the selected digit.
r Repeat steps w through e to make all of the required settings, and then
press the SET button.
Note
It is not possible to set the time in units of seconds. After setting the
minutes, press the SET button in sync with a time signal.
After completing all of the required settings, return to the Setup
Menu.
To do this, use the 6 or 7 buttons to select MENU and then press the SET
button.
Return to the normal screen display.
To do this, press the SET UP button
or
Select EXIT from the Setup Menu and press the SET button.
BUSY
OPEN/CLOSE
OPTION DV Y/C LINE
6 button
SET UP
SET UP button
t button
SET
MENU
SET button
8 button 7 button
27