Connecting the Units Note: Connection Diagram • This unit is for vehicles with a 12-volt battery and • When replacing the fuse, be sure to only use a fuse negative grounding. Before installing it in a recre- of the rating prescribed on the fuse holder. ational vehicle, truck, or bus, check the battery •...
Page 3
Installation A Title (English) Note: Installing the Unit • Before making a final installation of the unit, tem- • Install the antenna on as flat a place as possible. porarily connect the wiring to confirm that the con- • Do not paint the antenna, as this may affect its per- nections are correct and the system works properly.
Page 4
Installation Installing the Antenna Unit Route the antenna cable When routing the lead inside the trunk Installation using the magnet of antenna Waterproof pad Clamps Make sure the waterproof pad Use clamps to secure the 6 in. (15.5 cm) contacts the top of the rubber lead where necessary inside packing.