Device And Sim Card Security; Sensor Settings - Nokia 002M1S1 - E72 Smartphone 250 MB User Manual

To set the device to answer phone calls automatically after
5 seconds when an accessory is attached, select the
accessory and Automatic answer
type is set to Beep once
automatic answering is disabled.
To illuminate the device while it is attached to an
accessory, select Lights
for certain accessories.

Sensor settings

Select Menu Ctrl. panel
>
Sensors.
To set the device to silence an incoming call or snooze an
alarm when you turn the device face down, select
control.
Security settings
Security settings
Select Menu Ctrl. panel
>
Security.
Select from the following:
Phone and SIM card
•
your device and SIM card.
Certificate management
•
certificates.
Protected content
•
protected content.
Security module
•
114
> On. If the ringing
or Silent in the selected profile,
> On. This option is only available
Settings and General
>
Settings and General
>
— Modify the security settings for
— Manage your security
— Modify your settings for DRM-
— Manage your security module.
Avoid using codes that are similar to emergency numbers
to prevent accidental dialling of the emergency number.
Codes are shown as asterisks. When you change a code,
enter the current code, then the new code twice.

Device and SIM card security

To change the PIN code, select
PIN code. The new code must be 4 to 8 digits long. The
PIN code protects your SIM card against unauthorised use
and is provided with the SIM card. After three consecutive
incorrect PIN code entries, the code is blocked, and you
need to use the PUK code to unblock it before you can use
>
the SIM card again.
To set the keypad to lock automatically after a defined
period, select
Turning
period.
To set a time-out after which the device is automatically
locked and can be used only if the correct lock code is
entered, select
period. Enter a number for the time-out in minutes, or
select None to set off the autolock period. When the device
is locked, you can still answer incoming calls, and calls may
>
still be possible to the official emergency number
programmed into your device.
To set a new lock code, select
code. The preset lock code is 12345. Enter the current code
and then the new code twice. The new code can be 4-255
characters long. Both alphabets and digits can be used,
and both uppercase and lowercase alphabets are possible.
The device notifies you if the lock code is not properly
formatted.
Phone and SIM card
Phone and SIM card
>
Phone and SIM card
>
Phone and SIM card
>
Keypad autolock
Phone autolock
Lock
>