Perform Hardware Installation For Ir - Nokia 1261 - Cell Phone - AMPS User Manual

Pc/pda connectivity guide for the following nokia phones: 5100, 6100, 6200, 6610, 6800, 7210, 7250, and 7250i

Hide thumbs Also See for 1261 - Cell Phone - AMPS:

Table of Contents

Verify that your Nokia phone appears in the list of modems in the Modems Control Panel after rebooting your PC.

Complete the process by configuring your data software to work with the new modem installation. For more information, refer to

"Configure your data and fax software" on page 35.

• PERFORM HARDWARE INSTALLATION FOR IR

Even though you have installed the Nokia Modem Option software during PC Suite installation, if you want to use an IR

connection, you must complete the process by establishing an IR connection between your phone and PC. Depending on your phone

and your PC software configuration, Windows may automatically complete the installation once your phone is detected.

If the Windows new hardware wizard appears when your phone is first detected:

Click Next when Windows informs you that new hardware has been detected.

Clear any check boxes, then click Next and allow Windows to automatically locate the modem software already installed by

Nokia PC Suite.

Click Next to confirm that Windows has located the correct software for your phone.

Accept any Windows alert messages regarding digital signatures or hardware compatibility and continue the installation

process.

[ 31 ]

Wireless modem setup

Table of Contents

6200 - cell phone - at&t Pc suite 5.1 3361 - cell phone - amps