Din Front/Rear-Mount; Din Front-Mount - Pioneer AVIC N2 - Navigation System With DVD player Installation Manual

DIN Front/Rear-mount

This unit can be properly installed
either from "Front" (conventional DIN
Front-mount) or "Rear" (DIN Rear-
mount installation, using threaded
screw holes at the sides of unit chas-
sis). For details, refer to the following
illustrated installation methods.
Before installing the unit
• Remove the frame and the
holder.
To remove the frame, extend top and
bottom of the frame outwards in order
to unlock it.
Loosen the screws (2 × 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
• It becomes easy to remove the frame
if the front panel is released.
Holder
Screw (2 × 3 mm)

DIN Front-mount

Installation with the rubber bushing
1. Decide the position of the side
brackets.
When installing in a shallow space,
change the position of side brackets. In
this case, stick conceal tape on parts
that protrude from the dashboard.
Flush surface screw (5 × 6 mm)
2. Install the unit into the dash-
board.
After inserting the holder into the
dashboard, select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Dashboard
53
Frame
Holder
• After installing the unit into the
dashboard, reattach the frame.
• If you prefer an off-set installation
in which the front panel is pushed
further back, when there is a space
available at the back of the unit, use
AD-GA10 (sold separately).
Side bracket
182
Rubber bushing
Screw
Side bracket
Screw (2 × 3 mm)
Conceal tape
24