Compliance With International Regulations; Laser Product Label; Laser Information; Power Supply And Power Cord Set Requirements - HP ap5000 - All-in-One Point of Sale System Safety And Regulatory Information Manual

Compliance with International Regulations

All systems equipped with CD-ROM drives comply with appropriate safety standards including IEC 825.

Laser Product Label

The following label or equivalent is located on the surface of laser products:

Laser Information

●
Laser Type: Semiconductor GaAIAs
●
Wave Length: 780 +/- 35 nm
●
Divergence Angle: 53.5 Degrees +/- 0.5 degrees
●
Output Power: Less than 0.2 mW or 10,869 W·m-2 sr-1
●
Polarization: Circular 0.25
●
Numerical Aperture: 0.45 +/- 0.04

Power Supply and Power Cord Set Requirements

Power Supply Class I Grounding Requirements

For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the
system power cord into an AC outlet that provides a grounded outlet. Substitute cords may not provide
adequate fault protection. Only use the power cord supplied with this product or a Hewlett-Packard
authorized replacement.

Denmark

For tilslutning af de øvrige ledere, se medfølgende installationsvejledning.

Norway

Apparatet må kun tilkoples jordet stikkontakt.
4 Chapter 1 Safety Notices
This label indicates that the product is
classified as a CLASS 1 LASER
PRODUCT. This label appears on a laser
device installed in the product.
If you have an LS-120 drive or an LS-260
drive, this label is located next to the Class
1 Laser Product label on the system.
ENWW