HP Point of Sale rp5000 Manual page 6

Computer setup (f10) utility guide
Hide thumbs Also See for Point of Sale rp5000:
Table of Contents

Advertisement

Computer Setup (F10) Utility Guide
2
POST error occurs, the error is displayed regardless of the mode
selected. To manually switch to Post Messages Enabled during
POST, press any key (except
Establish an Ownership Tag, the text of which is displayed each
time the system is turned on or restarted.
Enter the Asset Tag or property identification number assigned
by your company to this computer.
Enable the power-on password prompt during system restarts
(warm boots) as well as during power-on.
Establish a setup password that controls access to the Computer
Setup (F10) Utility and the settings described in this section.
To secure integrated I/O functionality, including the serial, USB,
or parallel ports, audio, or embedded NIC, so that they cannot be
used until they are unsecured.
Enable or disable removable media boot ability.
Enable or disable removable media write ability (when supported
by hardware).
Solve system configuration errors detected but not automatically
fixed during the Power-On Self-Test (POST).
Replicate your system setup by saving system configuration
information on diskette and restoring it on one or more
computers.
Configure various energy-saving features including energy saver
mode, system and hard drive timeouts, power button mode, and
power LED behavior.
www.hp.com
F1
F12
through
).
Computer Setup (F10) Utility Guide

Advertisement

Table of Contents
loading

Table of Contents