Page 2
Note: Refer to your Barcode Manual for information about cleaning your device. For localized language versions of this document, go to www.honeywell.com/ aidc. Assembling the 4800dr Place arm on tray. Use the 3 screws provided to attach the arm to the underside of the tray.
Page 3
Place the imager in the stand. Press the cable firmly into the wire run along the back of the arm. (You must use the USB cable that’s supplied with the 4800dr or a compatible 5 volt pow- ered cable.)
Imager Mounting Details If you are planning to mount the imager in a fixed position, the following diagram shows the mounting hole placement and details. All measurements are in inches. Connecting to the Host Turn off computer’s power before connecting the document reader, then power up the computer once the document reader is fully connected.
Interface Scan the barcode that describes the PC or interface you are using. USB Keyboard (PC) USB Keyboard (Mac) USB Japanese Keyboard (PC) USB HID Barcode Reader USB COM Port Emulation TTL-232 Interface Aligning the Document Reader Tray Proper cable placement is important for accurate alignment of the device. Place the cable in the wire channel if the imager will remain in the base most of the time.
If you need assistance installing or troubleshooting your device, please call your distributor or the nearest technical support office: North America/Canada Telephone: (800) 782-4263 Fax number: (315) 554-6705 E-mail: natechsupport@honeywell.com Latin America Telephone: (803) 835-8000 Telephone: (800) 782-4263 E-mail: latechsupport@honeywell.com...
You can also access technical assistance online at www.honeywell.com/aidc. Product Service and Repair Honeywell International Inc. provides service for all its products through service centers throughout the world. To obtain warranty or non-warranty service, con- tact the appropriate location below to obtain a Return Material Authorization number (RMA #) before returning the product.
Limited Warranty Honeywell International Inc. ("HII") warrants its products to be free from defects in materials and workmanship and to conform to HII’s published specifications applicable to the products purchased at the time of shipment. This warranty does not cover any HII product which is (i) improperly installed or used;...
Page 10
The limited duration of the warranty for the 4800dr is for 3 (three) years. Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.
Page 12
Honeywell 700 Visions Drive P.O. Box 208 Skaneateles Falls, NY 13153-0208 4800dr-QS Rev B 4/09...