Section 1: Product Overview
Step 1:
Place the camera face down on a non-slip flat surface.
Step 2:
Carefully pry out the two protective rubber screw coverings using a thin flat blade.
Step 3:
Undo the two screws using a Philips #00 Screwdriver.
Step 4:
Lift off the protective panel.
Step 1:
Follow the steps outlined in "Removing the Bottom Panel" above.
Step 2:
Using a paperclip or similar tool, press and hold the Reset Button for 10 seconds. This will reset
the device to its factory settings.
Step 3:
Follow the steps outlined in "Reattaching the Bottom Panel" on page 16
D-Link DCS-2310L User Manual
Removing the Bottom Panel
Using the Reset Button
2
3
4
2
15