NEC LCD52VM - AccuSync - 15" LCD Monitor User Manual
User manual
Hide thumbs
Also See for LCD52VM - AccuSync - 15" LCD Monitor:
- User manual (46 pages) ,
- Technical specifications (2 pages) ,
- Specifications (2 pages)
Related Manuals for NEC LCD52VM - AccuSync - 15" LCD Monitor
Summary of Contents for NEC LCD52VM - AccuSync - 15" LCD Monitor
- Page 1 AccuSync LCD52VM AccuSync LCD72VM AccuSync LCD92VM User’s Manual...
-
Page 2: Declaration Of The Manufacturer
NERGY endorsement of any product or service. ErgoDesign is a registered trademark of NEC Display Solutions, Ltd. in Austria, Benelux, Denmark, France, Germany, Italy, Norway, Spain, Sweden, U.K.. IBM PC/XT/AT, PS/2, MCGA, VGA, 8514/A and XGA are registered trademarks of International Business Machines Corporation. -
Page 3: Canadian Department Of Communications Compliance Statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. U.S. Responsible Party: NEC Display Solutions of America, Inc. Address: 500 Park Blvd, Suite 1100 Itasca, Illinois 60143 Tel. -
Page 4: Quick Start
Contents Your new NEC AccuSync LCD monitor box* should contain the following: • AccuSync LCD monitor with tilt base • Audio Cable • Power Cord • Video Signal Cable • User’s Manual • CD-ROM • Base Stand • Cable Holder... -
Page 5: Remove Monitor Stand For Mounting
3. Connect the 15-pin mini D-SUB of the video signal cable and Audio Cable to the appropriate connector on the back of the monitor (Figure B.1). Connect the Headphone (not included) to the appropriate connector at the front of the monitor (Figure C.1). -
Page 6: Removing The Base
Non-abrasive surface Figure R.1 Figure R.2 Figure R.3 Removing the Base NOTE: Always remove the Base when shipping the LCD. 1. Place monitor face down on a non-abrasive surface (Figure R.1). 2. While using your thumbs, press the bottom tabs upward to unlock. 3. - Page 7 Controls OSM (On-Screen Manager) control buttons on the front of the monitor function as follows: 1. Basic function at pressing each key – SELECT AUTO / RESET Button At No OSD Shortcut to Bright adjust Shortcut to Volume adjust “Auto adjust” operate. Showing OSM.
-
Page 8: Auto Adjust
AUDIO Audio volume icon is chosen, depending on the volume condition (AUTO/RESET). BRIGHTNESS Adjusts the overall image and background screen brightness. CONTRAST Adjusts the image brightness in relation to the background. AUTO CONTRAST Adjusts the image displayed for non-standard video inputs. AUTO ADJUST Automatically adjusts the Image Position, the H. -
Page 9: Monitor Info
OSM LOCK OUT This control completely locks out access to all OSM control functions without Brightness and Contrast. When attempting to activate OSM controls while in the Lock Out mode, a screen will appear indicating the OSM are locked out. To activate the OSM Lock Out function, press “AUTO/ RESET”, then “+” key and hold down simultaneously. -
Page 10: Recommended Use
NOTE: As with all personal display devices, NEC DISPLAY SOLUTIONS recommends using a moving screen saver at regular intervals whenever the screen is idle or turning off the monitor when not in use. - Page 11 CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: • For optimum performance, allow 20 minutes for warm-up. • Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen.
- Page 12 Specifications AccuSync LCD52VM Monitor Monitor Specifications AccuSync LCD52VM Monitor Notes LCD Module Diagonal: 38 cm/15 inches Active matrix; thin film transistor (TFT) Viewable Image Size: 38 cm/15 inches liquid crystal display (LCD); 0.297 mm Native Resolution (Pixel Count): 1024 x 768 dot pitch;...
- Page 13 Specifications AccuSync LCD72VM Monitor Monitor Specifications AccuSync LCD72VM Monitor Notes LCD Module Diagonal: 43 cm/17 inches Active matrix; thin film transistor (TFT) Viewable Image Size: 43 cm/17 inches liquid crystal display (LCD); 0.264 mm dot Native Resolution (Pixel Count): 1280 x 1024 pitch;...
- Page 14 Specifications AccuSync LCD92VM Monitor Monitor Specifications AccuSync LCD92VM Monitor Notes LCD Module Diagonal: 48.3 cm/19 inches Active matrix; thin film transistor (TFT) Viewable Image Size: 48.3 cm/19 inches liquid crystal display (LCD); 0.294 mm dot Native Resolution (Pixel Count): 1280 x 1024 pitch;...
- Page 15 Features Reduced Footprint: Provides the ideal solution for environments requiring superior image quality but with size and weight limitations. The small footprint and low weight allow it to be moved or transported easily from one location to another. AccuColor Control Systems: Allows you to adjust the colours on your screen and customize the colour accuracy of your monitor to a variety of standards.
-
Page 16: Troubleshooting
NOTE: As with all personal display devices, NEC DISPLAY SOLUTIONS recommends using a screen saver at regular intervals whenever the screen is idle or turning off the monitor when not in use. Image is unstable, unfocused or swimming is apparent •... - Page 17 TCO’99 Congratulations! You have just purchased a Lead** TCO’99 approved and labelled product! Your Lead can be found in picture tubes, display screens, solders and choice has provided you with a product developed capacitors. Lead damages the nervous system and in higher for professional use.
- Page 18 This includes monitors and electrical accessories, such as signal cables or power cords. When you need to dispose of your NEC display products, please follow the guidance of your local authority, or ask the shop where you purchased the product, or if applicable, follow any agreements made between yourself and NEC.