About Ip290 Appliance Network Interface Cards; Two-Port Copper Gigabit Ethernet Nic; Table 4 Nic Pci Frequency - Nokia IP290 - Security Appliance Installation Manual

4
About IP290 Appliance Network
Interface Cards
This chapter describes the network interface cards (NICs) available for the Nokia IP290
appliance and how to connect those NICs to your network. The following NICs are described:

Two-Port Copper Gigabit Ethernet NIC

Two-Port Fiber-Optic Gigabit Ethernet NICs
For instructions about how to add or replace NICs, see
Network Interface Cards."
The NICs supported in the Nokia IP290 appliance operate at the peripheral component
interconnect (PCI) frequency listed in

Table 4 NIC PCI Frequency

NIC or interface port
Two-port copper Gigabit Ethernet
(10/100/1000 Mbps)
Two-port fiber-optic Gigabit Ethernet
(1000 Mbps)
Caution
To protect the IP290 appliance and the memory modules from electrostatic discharge
damage, make sure you are properly grounded before you touch these components.
Use a grounding wrist strap and follow the instructions provided with the wrist strap
before you handle the components or open the appliance.
Two-Port Copper Gigabit Ethernet NIC
The Nokia IP290 appliance supports Nokia-approved, two-port copper Gigabit Ethernet NICs
installed on a PMC expansion slot. The IP290 appliance can accommodate one Gigabit Ethernet
NIC.
Nokia IP290 Security Platform Installation Guide
Chapter 5, "Installing and Replacing
Table 4.
Maximum PCI operation
supported
66 MHz
66 MHz
39