Setup Completion; Activating The Ilo Port Using The License Key; Setting Up Ethernet Nic Teams (Optional) - HP 345646-001 - StorageWorks NAS 2000s External Storage Server Administration Manual

Basic Administrative Procedures and Setup Completion

Setup Completion

After the NAS device is physically set up and the basic configuration is established, additional
setup steps must be completed. Depending on the deployment scenario of the NAS device,
these steps may vary.
Additional setup steps may include:
Each of these setup steps is discussed in the following sections.

Activating the iLO Port Using the License Key

The Remote Desktop feature of the iLO port requires a license key. The key is included with
the product inside the Country Kit. Refer to the iLO Advanced License Pack for activation
instructions.
To access the iLO port, click on HP Utilities, then click Remote Management.

Setting up Ethernet NIC Teams (Optional)

The NAS 2000s is equipped with the HP Network Teaming and Configuration utility. The
utility allows administrators to configure and monitor Ethernet network interface controllers
(NIC) teams in a Windows-based operating system. These teams provide options for
increasing fault tolerance and throughput.
Fault tolerance provides automatic redundancy. If the primary NIC fails, the secondary NIC
takes over. Load Balancing provides the ability to balance transmissions across NICs.
Note:
configured.
Note:
Procedures include:
32
Activating the iLO port using the license key
Setting up Ethernet NIC teams (optional)
Managing system storage
Creating and managing users and groups
Creating and managing file shares
The NAS server ships with the NIC teaming utility available, however it must be installed and
Installing NIC teaming requires a restart of the server.
Installing the HP Network Teaming utility
Opening the HP Network Teaming utility
Adding and configuring NICs in a team
Configuring the NIC team properties
Checking the status of the team
NIC teaming troubleshooting
NAS 2000s Administration Guide